22LR Ammunition Spreadsheet


Email posted to Bullseye-L

EDITED 12/17/2016

The spreadsheet of 22LR ammunition velocities is as ready as it’s going to be (for a while). Several had requested copies and those have been mailed. (If you haven’t received yours, it’s because your Email service bounced my message. Sorry, I can’t do anything about that – but read on, all is not lost.)

The full report is available HERE.

So what have I learned from the spreadsheet?

First, please note that almost all of the listed velocities are measured by manufacturers – in rifles. And also please note that none of them state whether or not they were using any sort of mutually-used standard. Those two facts mean that 1) you probably won’t see these velocities out of your handgun, and 2) comparing one manufacturer’s ammo to that of another using this velocity data is, at best, debatable.

But experience does speak rather clearly sometimes.

For example, I’ve kept pretty good records on how different brands of ammunition have worked in my Smith and Wesson model 41. Having all the possibly-questionable velocities available, I can see a direct correlation between stove-piping and the manufacturer’s rifle-measured muzzle velocity even though I’m shooting a handgun. That is, once the rifle-measured muzzle velocity is above a certain number (about 1100 ft/sec), I’ll start to see stove-pipes in my S&W 41 and, as the velocity goes higher, the frequency of stove-pipes also goes up.

On the other end of the scale at the slow end, the problems I see in my 41 are typically not cycling the gun hard enough to eject the old round, nor cock the hammer. I end up pulling the trigger harder and harder until I realize it isn’t going to go bang! I haven’t fired enough subsonic to know where the dividing line is but it certainly looks like “rifle-measured muzzle velocity” will be a good way of deciding what to buy and what to avoid.

More generally, if you “mine” this data and pull out everything that says subsonic, you’ll find the average is about 1028 ft/sec. (The speed of sound is generally accepted as 1120 ft/sec at sea level, etc…)

The average “standard velocity” is 1092 ft/sec, still sub-sonic and, frankly, not that much faster than subsonic. That’s only a 6% difference. In addition, you’ll find that some brands of “standard” are slower than some brands of “subsonic”. CCI Standard Velocity, for example, is slower (at 1070 ft/sec) than Eley’s Subsonic (at 1085 ft/sec).

There’s a very wide range of velocities when it comes to “High Velocity,” anything from 1235 to to 1329 ft/sec, and all definately above the speed of sound.

Some of the manufacturers publish handgun-measured velocities as well. I’ve noted those values in addition to the rifle-measured velocities from the same manufacturer. The average difference (between rifle and handgun muzzle velocity) from these manufacturers is about 15%. That is, if someone tells you a rifle velocity, you may be able to subtract about 15% and come up with a pretty reasonable estimate of what you might see coming out the end of your handgun.

Well, maybe. It still depends on barrel length (shorter = slower), ambient temperature (lower = slower) and probably a dozen other factors as well.

That’s it for now.

Gotta get some range time in!

History

EDSkinner.net began in 2023. Fiction and non-fiction publications are included as well as (blog) posts and supplemental materials from flat5.net (2004-present).

Comments submitted on individual pages are subject to approval. General suggestions may be sent via the Contact page.

© Copyright 2024 by E D Skinner, All rights reserved